Hyundai Sonata: Accelerator Position Sensor (APS) Description and Operation - Engine Control System - Engine Control / Fuel SystemHyundai Sonata: Accelerator Position Sensor (APS) Description and Operation

Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line. The second sensor monitors the first sensor and its output voltage is half of the first one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the diagnostic system judges that it is abnormal.

    Rail Pressure Sensor (RPS) Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ConditionOutput Voltage (V)Idle Approx. 1.21, ...

    Accelerator Position Sensor (APS) Specifications
    Specification AcceleratorPositionOutput Voltage (V)APS1APS2C.T0.7 ~ 0.80.29 ~ 0.46W.O.T3.85 ~ 4.351.93 ~ 2.18 ...

    See also:

    Front Driveshaft Components and Components Location
    Components [THETA 2.4 GDI] 1. Driveshaft (LH)2. Driveshaft (RH)3. Heat protect [THETA 2.0 T-GDI / GAMMA1.6 T-GDI] 1. Driveshaft (LH)2. Driveshaft (RH)3. Inner shaft bearing bracket ass ...

    Components and Components Location
    Component Location [Engine Room] [Interior Relay] ...

    Sub Frame Repair procedures
    Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A).     Be careful not to damage to the wheel cap (A) when removing the it ...