Hyundai Sonata: Auto Head Lamp Leveling Unit Description and Operation - Auto Head Lamp Leveling Device - Body Electrical SystemHyundai Sonata: Auto Head Lamp Leveling Unit Description and Operation

Description
According to driving environment and loading state of vehicle, head lamp lighting direction is changed to keep the driver's visibility range and to protect the driver's vision from glare, aiming at safety driving.
Sensor integrated ECU mounting on the rear center arm drives the actuator mounting on the head lamp since sensing the input signal following the vehicle's statically changes.
Head lamp beam is automatically operated by chassis tilt.
Operation
Operating Procedure
1.
Suspension angle change resulted from vehicle's load change.
2.
Sensor angle change.
3.
Microprocessor calculates necessary head lamp angle change amount.
4.
Sending a proper signal to head lamp leveling device and driving actuator.
Operating Condition
1.
Ignition on
2.
Low beam on
3.
On stop : If sensor lever change is 0.3В° and above, head lamp is operated after max. 1.5 sec.
4.
On driving : If vehicle velocity is over 4km/h(2.48mile/h), velocity change is not over 0.8-1.6km/h(0.5 ~ 1.0mile/h) per second, and loading condition is changed, then head lamp is operated.
Components
1.
Auto head lamp leveling unit
1. Leveling unit & sensor
2. Sensor mounting bracket
3. Sensor linkage

A.
Using a Micro-processor, percept the operation lever's mechanical angle change or speed signal.
B.
As an actuator control device of inner control program, mounting on the rear center arm.
    Auto Head Lamp Leveling Unit Repair procedures
    Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check for operation. If the aim of the head lamps changes smoothly when the head lamp leveling switch is turned. 4. If ...

    See also:

    Water Jacket Seperator Repair procedures
    Remove and Installation 1. Remove the cylinder head assembly. (Refet to Cylinder Head Assembli - "Cylinder Head") 2. Remove the water jacket seperator (A).     Be careful n ...

    Rheostat. Repair procedures
    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the lower crash pad switch (A) from the side crash pad cover by usin ...

    Trunk lamp
    The trunk room lamp comes on when the trunk is opened. CAUTION The trunk lamp comes on as long as the trunk lid is open. To prevent unnecessary charging system drain, close the trunk lid secur ...