Hyundai Sonata: Blind Spot Detection Unit Repair procedures - Blind Spot Detection system - Body Electrical SystemHyundai Sonata: Blind Spot Detection Unit Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper.
(Refer to Body - "Rear Bumper")
3.
Remove the BSD unit (A) after loosening the mounting nuts.

   
Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Installation
1.
Install the BSD units to the rear bumper.
2.
Install the rear bumper.
3.
Connect the negative (-) battery terminal.
   
Take care not to confuse left side (master) and right side (slave) unit when installing.
BSD units connector connect to the wiring connector.
    See also:

    Seats
    Driver’s seat (1) Forward and backward (2) Seatback angle (3) Seat cushion height (4) Lumbar support* (5) Seat warmer* (6) Headrest Front passenger’s seat (7) Forward and backward (8) S ...

    Starter Relay. Repair procedures
    Inspection 1. Remove the fuse box cover. 2. Remove the starter relay (A). 3. Using an ohmmeter, check ...

    To turn cruise control off, do one of the following
    Push the cruise ON/OFF button (the CRUISE indicator light in the instrument cluster will go off). Turn the ignition off. Both of these actions cancel cruise control operation. If you wa ...