Hyundai Sonata: Blower Motor Repair procedures - Blower - Heating, Ventilation and Air ConditioningHyundai Sonata: Blower Motor Repair procedures

Inspection
1.
Connect the battery voltage and check the blower motor rotation.

2.
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.
3.
Replace the blower motor if it is proved that there is a problem with it.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cowl side trim.
(Refer to Body - "Cowl Side Trim")
3.
To remove the crash pad under cover [RH] (A), press both sides of the locking pin and then pull it down.

4.
Disconnect the under lamp connector (A).

5.
Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws.

6.
Install in the reverse order of removal.
    Blower Unit Repair procedures
    Replacement     When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent ...

    Power Mosfet Description and Operation
    Description It is installed to the DATC and adjusts the fan rpm by precisely controlling the voltage applied to the blower motor. ...

    See also:

    Multimedia jack. Description and Operation
    Description The multimedia jack on the console upper cover is for customers who like to listen to external portable music players like the MP3, iPod and etc., through the vehicle's sound ...

    Water pump. Components and Components Location
    Components 1. Water pump pulley 2. Water pump 3. Water pump gasket 4. Water pump housing 5. Water pump housing gasket 6. O-ring 7. Water inlet pipe 8. ...

    Manual Transaxle. Components and Components Location
    Components 1. Transaxle case 2. Taper roller bearing outer race 3. 1st/2nd shift fork 4. Reverse shift fork 5. Shift rail 6. 3rd/4th shift fork 7. 5th/6th ...