Hyundai Sonata: Boost Pressure Sensor (BPS) Repair procedures - Engine Control System - Engine Control / Fuel SystemHyundai Sonata: Boost Pressure Sensor (BPS) Repair procedures

Inspection
1.
Connect a GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the BPS at idle and IG ON.

Specification: Refer to "Specification"

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the boost pressure sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor.

Installation
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.

Boost pressure sensor installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Engine Coolant Temperature Sensor (ECTS) Description and Operation
    Description Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermistor that ...

    See also:

    Rear Shock Absorber Repair procedures
    Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A).     Be careful not to damage to the wheel cap (A) when removing the it ...

    BLUE LINK Unit Components and Components Location
    Component (Only for the audio TMU System)     The Blue Link unit for AVN is equipped in the AVN head unit. ...

    Air conditioning
    Press the A/C button to turn the air conditioning system on (indicator light will illuminate). Press the button again to turn the air conditioning system off. ...