Hyundai Sonata: Brake Line Repair procedures - Brake System - Brake SystemHyundai Sonata: Brake Line Repair procedures

Removal
1.
Disconnect the brake fiuid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservior with a syringe.
   
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
3.
Remove the wheel & tire.
4.
Disconnect the brake tube by loosening the tube flare nut (B).

Tightening torque:
12.7 ~16.7 N.m (1.3 ~1.7 kgf.m, 9.4 ~12.3 lb-ft)

Front

Rear

5.
Remove the brake hose clip (A).
6.
Disconnect the brake hose from the brake caliper by loosening the bolt (C).

Tightening torque:
24.5 ~29.4 N.m (2.5 ~3.0 kgf.m, 18.1 ~21.7 lb-ft)

[Front]

[General]

[EPB]

Inspection
1.
Check the brake tubes for cracks, crimps and corrosion.
2.
Check the brake hoses for cracks, damage and fluid leakage.
3.
Check the brake tube flare nuts for damage and fluid leakage.
4.
Check brake hose mounting bracket for crack or deformation.
Installation
1.
Installation is the reverse of removal.
   
Use a new washer (A) whenever installing.

2.
After installation, bleed the brake system.
(Refer to Brake System - "Brake System Bleeding")
(Refer to ABS - "ABS System Bleeding")
(Refer to ESP (Electronic Stability Program) System - "ESP System Bleeding")
3.
Check the spilled brake oil.
    Brake Pedal Components and Components Location
    Components 1. Brake member assembly2. Stop lamp switch3. Bolt4. Return spring5. Brake pedal assembly6. Locking plate ...

    See also:

    Crankshaft Position Sensor (CKPS). Repair procedures
    Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” ...

    SRS Control Module (SRSCM). Components and Components Location
    Components ...

    Engine start/stop button position
    OFF To turn off the engine, press the engine start/stop button with the engine start/stop button in the ON position and the shift lever in P(Park). When you press the engine start/stop button wit ...