Hyundai Sonata: Center Facia Upper Panel Repair procedures - Crash Pad - Body (Interior and Exterior)Hyundai Sonata: Center Facia Upper Panel Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the center facia lower panel assembly (A).

2.
Disconnect the A/C & heater controller connectors (A).

3.
Lower the steering wheel.
4.
Using a screwdriver or remover, remove the steering column shroud upper panel (A).

5.
Using a screwdriver or remover, remove the cluster facia upper panel assembly (A).

6.
After loosening the mounting screw, then remove the center facia upper panel assembly (A).

7.
Install in the reverse order of removal.
   
Replace any damage clips.
    Center Facia Upper Panel Components and Components Location
    Component Location 1. Center Facia Upper panel assembly ...

    Crash Pad Garnish Assembly [RH] Components and Components Location
    Component Location 1. Crash pad garnish assembly [RH] ...

    See also:

    Rear Door Belt Outside Weatherstrip Repair procedures
    Replacememt 1. Pull down rear door window glass by pressing the power window glass switch. 2. Remove the rear door belt outside weatherstrip (A). 3. Install in the reverse order of removal ...

    Components and Components Location
    Component Location 1. Air breather hose 2. Oil level plug 3. Valve body assembly 4. Oil temperature sensor 5. Solenoid valve 6. Valve body cover 7. Inhibitor swit ...

    Oil Pressure Switch Repair procedures
    Removal and Installation 1. Remove the under cover. 2. Remove the oil drain plug, and drain the oil into a container. 3. Remove the oil pressure switch (A). Tightening torque : 7.8 ~ ...