Hyundai Sonata: Cruise Control Switch Repair procedures - Cruise Control System - Engine Electrical SystemHyundai Sonata: Cruise Control Switch Repair procedures

Inspection
[Measuring Resistance]
1.
Disconnect the cruise control switch connector from the control switch.

2.
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
Function switch
Terminal
Resistance
SET -
3 - 5
550?±5%
RES +
3 - 5
880?±5%
CANCEL
3 - 5
330?±5%
CRUISE
3 - 5
1.4k?±5%

3.
If not within specification, replace switch.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel assembly.
(Refer to Steering System - "Steering Wheel")
3.
Remove the screw from the steering cover.

4.
Remove the steering back cover (A).

5.
Remove the steering remote control connector (A).

6.
Remove the steering remote control (A) after loosening the screw.

Installation
1.
Install in the reverse order of removal.
    See also:

    Components and Components Location
    Components Location 1. Input speed sensor 2. Output speed sensor 3. Solenoid valve connector 4. Oil temperature sensor 5. Valve body assembly 6. Solenoid va ...

    High Pressure Fuel Pump Repair procedures
    Removal     Whenever the high pressure fuel pump, fuel pipe, deliverypipe, or injector is removed immediately after shutting offthe engine, an injury may be caused by the rele ...

    Body Control Module (BCM). Components and Components Location
    Components ...