Hyundai Sonata: Curtain Airbag (CAB) Module Repair procedures - Airbag Module - RestraintHyundai Sonata: Curtain Airbag (CAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the roof trim.
(Refer to Body - "Roof Trim Assembly")
3.
Disconnect the curtain airbag harness connector.

4.
After loosening the mounting bolts and nuts remove the curtain airbag.

Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Tighten the curtain airbag mounting bolts and nuts.

Tightening torque :
6.9 ~ 8.8 N.m (0.7 ~ 0.9 kgf.m, 5.1 ~ 6.5 lb-ft)

   
Never twist the airbag module during installation. If the airbag module is twisted, the airbag module may operate abnormally.
4.
Connect the curtain airbag connector.
5.
Install the roof trim.
(Refer to Body - "Roof Trim Assembly")
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation :
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
    Knee Airbag (KAB) Module Description and Operation
    Description The Knee Airbag (KAB) is installed inside the crash pad lower panel and protects the driver in the event of a frontal crash. The SRSCM determines if and when to deploy the KAB. ...

    See also:

    Schematic Diagrams
    Schematic Diagram ...

    Auto down window (if equipped) (driver’s window)
    Pressing the power window switch momentarily to the second detent position (6) completely lowers the driver’s window even when the switch is released. To stop the window at the desired posit ...

    Rear Cross Member. Repair procedures
    Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...