Hyundai Sonata: CVVT Oil Control Valve (OCV) Repair procedures - Engine Control System - Engine Control / Fuel SystemHyundai Sonata: CVVT Oil Control Valve (OCV) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the CVVT oil control valve connector (A).
3.
Remove the installation bolt (B), and then remove the valve from the engine.
[Bank 1 / Intake]

[Bank 1 / Exhaust]

Installation
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
Apply engine oil to the valve O-ring.
1.
Install in the reverse order of removal.

CVVT oil control valve installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Electric WGT Control Actuator Description and Operation
    Desrcription The Electric WGT Control Actuator is installed on the turbocharger.It operates the vain in the Waste Gate Turbocharger (WGT) and regulates the compressed air amount by the ECM's PW ...

    See also:

    Front Body. Body Repair
    Front Body A Front Body B Front Body C ...

    Water pump Repair procedures
    Removal 1. Loosen the drain plug (A), and drain the engine coolant. Remove the radiator cap to drain with speed.     System is under high pressure when the engine is hot.To avoi ...

    Automatic heating and air conditioning
    1. Press the AUTO button. The modes, fan speeds, air intake and air-conditioning will be controlled automatically according to the temperature setting. Type A Type B 2. Turn the tempe ...