Hyundai Sonata: Description and Operation - Ignition System - Engine Electrical SystemHyundai Sonata: Description and Operation

Description
Ignition timing is controlled by the electronic control ignition timing system.
The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module).
The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.
The ignition coil is activated, and timing is controlled.
    Repair procedures
    On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.     • If a DTC is present, perform troubleshooting in accordance with the ...

    See also:

    Engine compartment
    ■ 2.4 GDI 1. Engine coolant reservoir 2. Engine oil filler cap 3. Brake fluid reservoir 4. Air cleaner 5. Fuse box 6. Positive battery terminal 7. Negative battery terminal 8. Windshie ...

    Memory power seat unit Components and Components Location
    Components NoConnecter AConnecter BConnecter CConnecter D1-Batt (+)--2Front tilt motor (Up)GND-Seat rear height sensor3Rear height motor (Up)Batt (+)Slide switch signal (Forward)-4Reclining motor ...

    Smart key unit. Components and Components Location
    Component (1) Connector Pin Information Pin Connector A Pin Connector B 1 Battery 1 Interior 2 an ...