Hyundai Sonata: Description and Operation - Tire Pressure Monitoring System - Suspension SystemHyundai Sonata: Description and Operation

Description
The Tire Pressure Monitoring System (TPMS) monitors the pressure and temperature inside the tire in order to warn the driver of changes in pressure which may influence the operation of the vehicle. The TPMS control module analyzes wireless information fro
In other words, the system detects the pneumatic pressure of the tires and warns the driver of if the pneumatic pressure drops below the standard level.
Low-pressure Warning Lamp on the Dashboard
Dashboard tire low-pressure warning light

Lamp ON/OFF Conditions when the Tire Pressure Decreases or Air is Leaking from the Tire
1.
Lamp ON
A.
The lamp turns ON when the tire pressure decreases below the standard level.
2.
Lamp OFF
A.
Low pneumatic pressure: The warning lamp turns OFF when the tire pressure exceeds the pressure required to turn off the lamp.
TPMS Fault Warning Lamp
1.
Warning Conditions and Display
A.
When the system detects a defect in the external operating environment (low battery voltage, abnormal vehicle speed, etc), the warning lamp blinks for about 1 minute and then turns ON.
2.
Lamp OFF
A.
The warning lamp turns OFF when the DTC is resolved. The DTC is automatically resolved when the system does not receive any fault signals for 30 or more ignition cycles after it changes to the previous fault code.
   
If this phenomenon occurs while driving, you should check the cause of the fault even after the DTC is resolved.
(Turn the ignition switch from OFF to ON. Then, check the lamp status.)
The warning lamp turns off once the DTC is resolved. The warning lamp stays on until you complete the check necessary to resolve the DTC.
If the DTC is resolved, the warning lamp turns OFF during the same ignition cycle.
System Defect
1.
General Operation
A.
The system detects many input elements to identify potential defects.
B.
The priority of a defect depends on its cause.
C.
Certain defects are not diagnosed as DTCs.
The following are major defects:
A.
In order to diagnose more symptoms of the fault when the ignition line malfunctions, you must check the warning lamp when you turn the ignition on.
B.
Check whether the warning lamp turns on and then off.
    Components and Components Location
    Components 1. Receiver2. TPMS sensor (FL)3. TPMS sensor (RL)4. TPMS sensor (FR)5. TPMS sensor (RR) ...

    TPMS Sensor Description and Operation
    Configuration State 1. Driving state Sensor transmissions occur every 1 minutes and pressure is measured every 15 seconds. 2. Stationary state Sensor transmissions does not occur and pressur ...

    See also:

    Heated Oxygen Sensor (HO2S). Description and Operation
    Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies ...

    CVVT Oil Control Valve (OCV) Description and Operation
    Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by ...

    Components and Components Location
    Components 1. Hands free call switch 2. Mic 3. Front left speaker 4. Front right speaker 5. Audio head unit (hands free control) R ...