Hyundai Sonata: ETC (Electronic Throttle Control) System Repair procedures - Engine Control System - Engine Control / Fuel SystemHyundai Sonata: ETC (Electronic Throttle Control) System Repair procedures

Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.

Specification: Refer to “Specification”

ETC Motor
1.
Turn the ignition switch OFF.
2.
Disconnect the ETC module connector.
3.
Measure resistance between the ETC module terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the resonator and the air intake hose.
(Refer to Engine Mechanical System - “Air Cleaner”)
3.
Disconnect the ETC module connector (A).

4.
Remove the installation bolts, and then remove the ETC module (A) from the engine.

Installation
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.

Electronic throttle body Installation bolt:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.2 lb-ft)

Adjustment
ETC module learning procedure
When installing new ETC module or re-installing it, ETC module learning procedure must be performed.
1.
Hold the ignition key or the start button at th IG ON position during 5 seconds.
2.
Turn ignition swich OFF and then start the engine.
   
DTC codes (P0638, P2110) might be displayed if ETC module learning procedure does not performed after replacing ETC module.
    Manifold Absolute Pressure Sensor (MAPS) Description and Operation
    Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog si ...

    See also:

    Roof Trim Assembly Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply pr ...

    Driver Airbag (DAB) Module and Clock Spring Repair procedures
    Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the driver airbag module from the steering wheel after pressing the snap ...

    Battery Sensor Repair procedures
    Removal 1. Disconnect the battery negative (-) cable. 2. Disconnect the battery sensor connector (A). 3. Remove the battery negative (-) cable after removing the bolts (B). Installation ...