Hyundai Sonata: Evaporator Core Repair procedures - Heater - Heating, Ventilation and Air ConditioningHyundai Sonata: Evaporator Core Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
After loosening the bolts remove the main crash pad and cowl cross bar assembly together.
(Refer to Heater -"Heater Unit")
3.
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
4.
Separate the blower unit (B) from the heater unit (A) after loosening the screws.

5.
Remove the heater unit lower case mounting clip (A).
6.
Remove the heater unit lower case (B) after loosening the mounting screws.

7.
Pull out the evaporator core (A) from the heater unit.

8.
Install in the reverse order of removal.
A.
If you're installing a new heater core, add refrigerant oil (PAG OIL).
B.
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
C.
Immediately after using the oil, replace the cap on the container, and seal it to avoid moisture absorption.
D.
Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
E.
Apply sealant to the grommets.
F.
Make sure that there is no air leakage.
G.
Charge the system and test its performance.
H.
Do not interchange the inlet and outlet heater hoses and install the hose clamps securely.
    Heater Core Repair procedures
    Replacement 1. Disconnect the negative (-) battery terminal. 2. After loosening the bolts remove the main crash pad and cowl cross bar assembly together. (Refer to Heater -"Heater Unit") ...

    Temperature Control Actuator Components and Components Location
    Components Location 1. Temperature control actuator [LH]2. Temperature control actuator [RH] ...

    See also:

    Description and Operation
    System Overview RPAS (Rear Parking Assist System) is an electronic driving aid that warns the driver to be cautious while parking or in low speed environments. The sensor uses ultrasonic waves ...

    Seat belt warning (for driver’s seat)
    The driver's seat belt warning light and chime will activate to the following table when the ignition switch is in "ON" position. *1 Warning pattern repeats 11 times with an inter ...

    Instrument Cluster. Repair procedures
    Inspection Speedometer 1. Adjust the pressure of the tires to the specified level. 2. Drive the vehicle onto a speedometer tester. Use whee ...