Hyundai Sonata: Filler-Neck Assembly Repair procedures - Fuel Delivery System - Engine Control / Fuel SystemHyundai Sonata: Filler-Neck Assembly Repair procedures

Removal
1.
Turn the ignition seitch OFF and disconnect the battery negative (-) cable.
2.
Open the fuel filler door and then remove the filler-neck installation screw (A).

3.
Lift the vehicle.
4.
Remove the rear-LH wheel, tire, and the inner wheel house.
5.
Remove the rear sub frame.
( Refer to Suspension System - " Rear Sub Frame ")
6.
Disconnect the canister close valve connector (A).

7.
Disconnect the fuel filler hose (A).
8.
Disconnect the ventilation hose (B) from the fuel tank air filter.

9.
Remove the filler-neck assembly from the vehicle after removing the bracket installation bolt (A).

Installation
1.
Install in the reverse order of removal.

Filler-neck assembly bracket installation bolt :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Filler-neck assembly installation screw :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lbf.ft)

    Fuel Line Repair procedures
    Removal     Whenever the high pressure fuel pump, fuel pipe, deliverypipe, or injector is removed immediately after shutting offthe engine, an injury may be caused by the rele ...

    Accelerator Pedal Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the mounting cap (A). 4. ...

    See also:

    Auto Head Lamp Leveling Unit Troubleshooting
    Inspection with GDS Initialization and diagnosis sequence by using GDS equipment. Below content summarize the procedure for A/S using GDS. NoProcedure1Locate vehicle to flat plane2Tire check3IG ...

    Seats
    Driver’s seat (1) Forward and backward (2) Seatback angle (3) Seat cushion height (4) Lumbar support* (5) Seat warmer* (6) Headrest Front passenger’s seat (7) Forward and backward (8) S ...

    Rear Combination Lamp Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Loose the nuts (4EA) holding the rear combination lamp then disconnect the connector (A) then remove the outside rear combination ...