Hyundai Sonata: Floor Console Assembly Repair procedures - Floor Console - Body (Interior and Exterior)Hyundai Sonata: Floor Console Assembly Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the gear knob & boots (A) pull both of it up.

2.
Remove the tray (B) by using remover holder hole after removing the rubber mat (A).

3.
Using a screwdriver or remover, remove the front console upper cover (A).

4.
Disconnect the connectors (A).

5.
Remove the console armrest tray (A).

6.
Remove the storage box pad (A).

7.
After loosening the mounting screws and bolts, then remove the console rear complete assembly (A).

8.
Disconnect the multimedia jcak connectors (A).

9.
After loosening the mounting screws, then remove the console front complete assembly (A).

10.
Install in the reverse order of removal.
   
Make sure the connector is connected properly.
Replace any damage clips.
    Floor Console Assembly Components and Components Location
    Component Location 1. Floor console assembly ...

    Console Armrest Components and Components Location
    Component Location 1. Front console armrest ...

    See also:

    Power Seat Control Switch. Repair procedures
    Inspection With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. A ...

    Accelerator Position Sensor (APS). Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the ...

    Main Crash Pad Assembly Components and Components Location
    Component Location 1. Main crash pad assembly ...