Hyundai Sonata: Front Seat Cushion Cover Repair procedures - Front Seat - Body (Interior and Exterior)Hyundai Sonata: Front Seat Cushion Cover Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the front seat outer shield cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover")
3.
Remove the front seat shield inner cover.
(Refer to Front Seat - "Front Seat Shield Inner Cover")
4.
After loosening the mounting clip and screws, then remove the front seat under cover (A).

5.
Disconnect the connectors (A).

6.
Remove the front seat air ventilation seat cushion duct (A).

7.
Pull out the protectors (A), and then front seat cushion cover from the front seat cushion frame (B).

8.
Remove the front seat cushion cover (A) from the front seat cushion frame.

9.
After removing the velcro tape (A) and clips (B) on the front of seat back and remove the front seat back cover (C).
   
Be careful not to allow the sponge insert wire to separated in its place.

10.
Install in the reverse order of removal.
   
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the clips (A).
    Front Seat Cushion Cover Components and Components Location
    Component Location 1. Front seat cushion cover ...

    Front Seat Frame Assembly Components and Components Location
    Component Location 1. Front seat back frame assembly2. Front seat cushion frame assembly ...

    See also:

    Hands Free Switch. Repair procedures
    Inspection 1. Check the hands free remote control switch for resistance between No.3 and No.4 terminals in each switch position. ...

    Radiator Grill Components and Components Location
    Component Location 1. Radiator grill ...

    Mode Control Actuator Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to ...