Hyundai Sonata: Fuel Pump Control Module (FPCM) Description and Operation - Fuel Delivery System - Engine Control / Fuel SystemHyundai Sonata: Fuel Pump Control Module (FPCM) Description and Operation

Description
The fuel pump control module (FPCM) is installed on the right side of the fuel tank on the fuel pump top plate and controls the DC motor mounted inside the low pressure fuel pump.
The module compares instantaneous fuel pressure information measured by the fuel pressure sensor (FPS) with target fuel pressure information provided by the ECM and generates the desired target fuel pressure by controlling the fuel pump motor and regulating fuel flow rate in the low pressure fuel line between the low and high pressure fuel pumps.

Operation

1.
The ECM provides target fuel pressure information to the FPCM via CAN network.
2.
The FPS provides the FPCM with actual pressure information of the low pressure fuel line between the low and high pressure fuel pumps, and the FPCM forwards the information to the ECM.Also, the FPCM diagnoses faults in the FPCM, fuel pump motor and FPS and then provides the diagnosis information to the ECM.
3.
The FPCM compares the actual fuel pressure information measured by the FPS with the target fuel pressure information provided by the ECM and controls the voltage that is provided to the low pressure fuel pump motor.The FPCM keeps regulating fuel flow rate by controlling the low pressure fuel pump, depending on engine speed (rpm) and vehicle loads.
    Fuel Pressure Regulator Repair procedures
    Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Remove the fuel pressure regulator fixing clip (A). 3. Remove the fuel pressure regulator (B) from the fu ...

    Fuel Pump Control Module (FPCM) Specifications
    Specification ItemsSpecificationApplied Voltate (V)6~18Current Consumption (A)Max. 15Fuel Pressure StartMax. 600 KPa (Max. 6.1 kgf/cm?, Max. 87.0 psi)In operation350 ~ 500 KPa (3.5 ~ 5.1 kgf ...

    See also:

    Side Impact Sensor (SIS) Description and Operation
    Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar n ...

    Power Seat Control Switch. Schematic Diagrams
    Circuit Diagram ...

    Care of disc
    If the temperature inside the car is too high, open the car windows to ventilate before using the system. It is illegal to copy and use MP3/WMA files without permission. Use CDs that are cr ...