Hyundai Sonata: Fuel Pump Repair procedures - Fuel Delivery System - Engine Control / Fuel SystemHyundai Sonata: Fuel Pump Repair procedures

Inspection
[Fuel sender]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
3.
Using an ohmmeter, measure the resistance between terminals 1 and 6 of sender connector (A) at each float level.

Pin No.
Description
1
Fuel sender ground
2
Fuel pressure sensor (FPS) signal input
3
CAN [High]
4
Fuel pressure sensor (FPS)
power supply (+5V)
5
Fuel pressure sensor (FPS) ground (-)
6
Fuel sender signal
7
-
8
CAN [Low]
9
Ground
10
Battery power (B+)

4.
Also check that the resistance changes smoothly when the float is moved from "E" to "F".
[ Analog cluster type]
Posion
Resistance (?)
Capacity (?)
E
298 ~ 305
3
 1/2
80 ~ 84
35.7
F
14 ~ 16
68.6

[Digital cluster type]
Posion
Resistance (?)
Capacity (?)
E
298 ~ 305
3
 1/2
80 ~ 84
35.7
F
14 ~ 16
68.6

Removal
1.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - "Release Residual Pressure in Fuel Line")
2.
Lift the vehicle.
3.
Support the fuel tank with a jack.
4.
Pull fuel tank in direction of a down by loosening the mounting nut (A) appropriately.

5.
Remove the rear seat cushion.
(Refer to Body - "Rear Seat Assembly")
6.
Remove the fuel pump service cover (A).

7.
Disconnect the fuel pump control module connector (A).
8.
Disconnect the fuel feed tube quick-connector (B).
9.
Disconnect the fuel pressure sensor connector (C).

10.
Remove the locking ring (A) by using the special service tool (B) [No.: 09310-B9100].

11.
Remove the fuel pump from the fuel tank.

Installation
1.
Install in the reverse order of removal.
   
Be careful of fuel pump direction (Refer to the groove in the fuel tank).

Fuel pump plate cover installation bolt :
2.0 ~ 2.9 N.m (0.2 ~ 0.3 kgf.m, 1.4 ~ 2.2 lb-ft)

    Fuel Tank Repair procedures
    Removal 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Remove the rear seat cushion. (Refer to Body - "Rear ...

    Fuel Filter Repair procedures
    Replacement 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Remove the fixing clip (A), and then disconnect the fuel tube (B). 3. Remove the fuel pressure regul ...

    See also:

    Front Driveshaft. Components and Components Location
    Component location 1. Driveshaft(LH) 2. Circlip 3. Transaxle 3. Circlip 4. Driveshaft(RH) 1. Driveshaft (LH) 2. Circlip ...

    Master Cylinder. Components and Components Location
    Components 1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder ...

    Trunk Lid Trim Components and Components Location
    Component Location 1. Trunk lid trim ...