Hyundai Sonata: General Information - Body Dimensions - Body (Interior and Exterior)Hyundai Sonata: General Information

General
1.
Basically, all measurements in this manual are taken with a tracking gauge.
2.
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
3.
For measuring dimensions, both projected dimension and actual-measurement dimension are used in this manual.
4.
This measurements are provided as reference for A/S, so it can not be used as specification.
Measurement Method
Projected Dimensions
1.
These are the dimensions measured when the measurement points are projected into the reference plane, and are the reference dimensions used for body alterations.
2.
If the length of the tracking gauge probes is adjustable, make the measurement by lengthening one probe by the amount equivalent to the difference in height of the two surfaces.

Actual-Measurement Dimensions
1.
These dimensions indicate the actual linear distance between measurement points, and are the reference dimensions for use if a tracking gauge is used for measurement.
2.
Measure by first adjusting both probes to the same length (A=A').
   
Check the probes and gauge itself to make sure there is no free play.

Measurement Point
1.
Measurements should be taken at the hole center.

   
You should measure the center of outer panel (hole).

    Front Body Body Repair
    Front Body A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front Body B * These dimensions indicated in this figure are actual-measurem ...

    See also:

    Troubleshooting
    Trouble Symptom Charts Trouble Symptom 1 Trouble Symptom 2 Trouble symptomProbable causeRemedyThe set vehicle speed varies greatly upward or downward"Surging" (repeated alternating accelera ...

    Wiper blades
    Blade inspection ✽ NOTICE Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean. Contamination of either the windshield or the ...

    Rear Combination Lamp Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Loose the nuts (4EA) holding the rear combination lamp then disconnect the connector (A) then remove the outside rear combination ...