Hyundai Sonata: Heated Oxygen Sensor (HO2S) Description and Operation - Engine Control System - Engine Control / Fuel SystemHyundai Sonata: Heated Oxygen Sensor (HO2S) Description and Operation

Description
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance with the air/fuel ratio.
The sensor must be hot in order to operate normally. To keep it hot, the sensor has a heater which is controlled by the ECM via a duty cycle signal. When the exhaust gas temperature is lower than the specified value, the heater warms the sensor tip.

    Knock Sensor (KS) Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). 3. Disconnect ...

    Heated Oxygen Sensor (HO2S) Specifications
    Specification HO2S [Bank 1/Sensor 1] (Linear type) ItemSpecificationHeater Resistance (?)2.4 ~ 4.0 [20°C(68°F)] ItemSpecificationHeater Resistance (?)Approx. 9.0 [20°C(68°F)] HO2S [Ba ...

    See also:

    Steering Angle Sensor Specifications
    Specification Service Standard DescriptionSpecificationOperating voltage8 ~ 16VOperating temperature-40 ~ 85°C(-40 ~ 185°F)Current consumptionMax.150mAMeasuring rangeAngle-780 ~ 779.9°Angula ...

    Repair procedures
    Adjustment Inspect Glass Alignment 1. Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it. Alignment adjustment Standard v ...

    Power Door Lock Module Repair procedures
    Inspection     • Wrap the protective tape on the tool to disassemble with the screwdriver or remover. • Use caution in keeping and handling during disassembling/asse ...