Hyundai Sonata: Heater Core Repair procedures - Heater - Heating, Ventilation and Air ConditioningHyundai Sonata: Heater Core Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
After loosening the bolts remove the main crash pad and cowl cross bar assembly together.
(Refer to Heater -"Heater Unit")
3.
Remove the heater core cover (A) after loosening the mounting screws.

4.
Pull out the heater core (A) from the heater unit.

5.
Install in the reverse order of removal.
A.
If you're installing a new heater core, add refrigerant oil (PAG OIL).
B.
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
C.
Immediately after using the oil, replace the cap on the container, and seal it to avoid moisture absorption.
D.
Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
E.
Apply sealant to the grommets.
F.
Make sure that there is no air leakage.
G.
Charge the system and test its performance.
H.
Do not interchange the inlet and outlet heater hoses and install the hose clamps securely.
    Heater Unit Repair procedures
    Replacement     When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent ...

    Evaporator Core Repair procedures
    Replacement 1. Disconnect the negative (-) battery terminal. 2. After loosening the bolts remove the main crash pad and cowl cross bar assembly together. (Refer to Heater -"Heater Unit") ...

    See also:

    Inhibitor Switch Specifications
    Specifications ? Type: Combination of output signals from 4 terminals ? Specifications ItemSpecificationsOutput typeCombination of output signalsPower supply (V)12 Signal Code Table ...

    Cylinder Head Cover Repair procedures
    Removal 1. Remove the engine cover. 2. Disconnect the battery negative terminal. 3. Remove the air clean hose. (Refer to Intake and Exhaust System - "Ari Cleaner") 4. Disconnect the ...

    Side Body. Body Repair
    Side Body A Side Body B ...