Hyundai Sonata: Immobilizer Control Unit Repair procedures - Immobilizer System - Body Electrical SystemHyundai Sonata: Immobilizer Control Unit Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the knee airbag module.
(Refer to Restraint - "Knee Airbag (KAB) Module")
4.
Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a nut.

Installation
1.
Install the immobilizer control unit after connecting the unit connector.
2.
Install the crash pad lower panel and knee airbag module.
3.
Connect the negative (-) battery terminal.
    Repair procedures
    Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with a ...

    Antenna Coil Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Disconnect the 6P connector (B) of the coil ante ...

    See also:

    Side Airbag (SAB) Module Repair procedures
    Removal     The side airbag cannot be disassembled from the seat back assembly, so replace the seat back assembly when replacing the side airbag. 1. Disconnect the batter ...

    Flex Steer. Repair procedures
    Inspection 1. Check the audio remote control switch for resistance between terminals in each switch position. Switch Connector ...

    Canister Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the fuel tank. (Refer to Engine Control / Fuel System - " Fuel Tank") 3. Disconnect th ...