Hyundai Sonata: Input shaft speed sensor 1 Repair procedures - Dual Clutch Transmission Control System - DCT (Dual Clutch Transmission) SystemHyundai Sonata: Input shaft speed sensor 1 Repair procedures

Removal
1.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechnical System - "Air cleaner")
2.
Remove the TCM.
(Refer to Dual Clutch Transmission Control System - "TCM")
3.
Remove the battery and tray.
(Refer to Engine Electrical System - "Battery")
4.
Remove the clutch actuator.
(Refer to Dual Clutch Transmission Control System - "Clutch Actuator")
5.
Disconnect the input shaft speed sensor (A).

6.
Remove the input shaft speed sensor after removing the bolt (A-2ea).

Installation
1.
Install in the reverse order of removal.
   
Before installing the input speed sensor,check the assembled state of the O-rings (A) and should apply gear oil to the surface of O- rings.

    Input shaft speed sensor 2 Components and Components Location
    Components 1. Input shaft speed sensor 1 (Odd)2. Input shaft speed sensor 2 (Even) ...

    See also:

    Specifications
    Specifications Ignition System Items Specifications Ignition coil Primary resistance 0.62 ± 10 % (Ω) Secondary ...

    Occupant Classification Sensor (OCS) Description and Operation
    Description In order to make normal activation of airbag system, SRSCM detects DTC(s) for the Occupant Classification System (OCS). If the seat is occupied, OCS detects passenger presences stat ...

    Schematic Diagrams
    Circuit Diagram NoSunroof wiringconnector(Vehicle side)Sunroof wiringconnector(Motor)Panorama glass motor(Master)Blind motor(Slave)1GND 1 GND 1GND 22Glass statussignal / tool(parameter)Glass sta ...