Hyundai Sonata: Input shaft speed sensor 2 Repair procedures - Dual Clutch Transmission Control System - DCT (Dual Clutch Transmission) SystemHyundai Sonata: Input shaft speed sensor 2 Repair procedures

Removal
1.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechnical System - "Air cleaner")
2.
Remove the battery and tray.
(Refer to Engine Electrical System - "Battery")
3.
Remove the clutch actuator.
(Refer to Dual Clutch Control System - "Clutch Actuator")
4.
Disconnect the input shaft speed sensor (A).

5.
Remove the input shaft speed sensor after removing the bolt (A-2ea).

Installation
1.
Install in the reverse order of removal.
   
•
Before installing the input speed sensor,check the assembled state of the O-rings (A) and should apply gear oil to the surface of O- rings.

    Inhibitor Switch Components and Components Location
    Components 1. Inhibitor switch2. Manual control lever ...

    See also:

    TPMS Receiver Schematic Diagrams
    Circuit Diagram Terminal function Pin NO.Discription1Battery (+)2IGN3CAN_Low4CAN_High5-6Ground ...

    Rail Pressure Sensor (RPS) Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ConditionOutput Voltage (V)Idle Approx. 1.21, ...

    Rear Assist Arm. Repair procedures
    Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...