Hyundai Sonata: Intake Air Temperature Sensor (IATS) Repair procedures - Engine Control System - Engine Control / Fuel SystemHyundai Sonata: Intake Air Temperature Sensor (IATS) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

    Ambient Temperature Sensor (ATS) Description and Operation
    Description Ambient Temperature Sensor (ATS) is installed on the front-end module and senses the ambient temperature. ECM receives not only the intake air temperatue but also the ambient air te ...

    See also:

    Checking the amount of air conditioner refrigerant and compressor lubricant
    When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a negative influence on the air conditioning system. Therefore, if abnormal operation ...

    Wheel alignment and tire balance
    The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance. In most cases, you will not need to have your wheels al ...

    CVVT & Camshaft Repair procedures
    Removal 1. Remove the cylinder head cover. (Refer to Cylinder Head Assembly - "Cylinder Head Cover") 2. Turn the crankshaft damper pulley so that No. 1 piston is at top dead center. (1) Tu ...