Hyundai Sonata: Intake Manifold Repair procedures - Intake And Exhaust System - Engine Mechanical SystemHyundai Sonata: Intake Manifold Repair procedures

Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
3.
Disconnect the engine wiring connector and haness clamp and disconnect the wiring from intake manifold.

4.
Disconnect the PCV (Positive crankcase ventilation) hose (A) and the PCSV (Purge control solenoid valve) (B).

5.
Remove the intercooler outlet hose (A).

Tightening torque:
4.9 ~ 6.8 N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.0 lb-ft)

6.
Remove the installation bolts, and then remove the ETC module (A) from the engine.

Electronic throttle body Installation bolt:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.2 lb-ft)

7.
Disconnect the vacuum hose (A).

8.
Remove the intake manifold (A) with the gasket.

Tightening torque :
18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)

   
When installing, replace with new gaskets.
When installing the intake manifold, tighten the bolts and nuts with pre-torque first, and then tighten the bolts and nuts with specified torque in the sequence shown.

9.
Install in the reverse order of removal.
    Intake Manifold Components and Components Location
    Components 1. Intake manifold assembly2. Intake manifold gasket3. Electronic throttle body gasket4. Electronic throttle body ...

    Exhaust Manifold Components and Components Location
    Components 1. Turbo manifold gasket2. Turbo manifold module3. Turbo charger coupler4. Turbo charger coupler & gasket5. Oil feed pipe & hose assembly6. Oil drain pipe assembly7. Turbo mani ...

    See also:

    Rear Shock Absorber Repair procedures
    Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A).     Be careful not to damage to the wheel cap (A) when removing the it ...

    Yaw-rate and Lateral G Sensor. Description and Operation
    Description When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly by the vibration change of plate fork inside the yaw rate senso ...

    Relay Box (Engine Compartment) Repair procedures
    Inspection 1. Disconnect the negative (-) battery terminal. 2. Pull out the relay from the engine compartment relay block. Power Relay (Type A) Check for continuity between the terminals. ...