Hyundai Sonata: Knee Airbag (KAB) Module Repair procedures - Airbag Module - RestraintHyundai Sonata: Knee Airbag (KAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the mounting nuts (A).
4.
Disconnect the knee airbag connector (B).

Installation
1.
Disconnect the battery negative cable and wait for at least three minutes.
2.
Install the knee airbag.

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

3.
Install the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
4.
Reconnect the battery negative cable.
5.
After installing the knee airbag, confirm proper system operation.
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.
    Airbag Module Disposal Description and Operation
    Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those installed in vehicle to be scrapped), the airbags or side air ...

    See also:

    Rear Door Window Glass Repair procedures
    Replacement 1. Pull down rear door window glass by pressing the power window glass switch. 2. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 3. Remove the rear door b ...

    Schematic Diagrams
    Circuit Diagram NoSunroof wiringconnector(Vehicle side)Sunroof wiringconnector(Motor)Panorama glass motor(Master)Blind motor(Slave)1GND 1 GND 1GND 22Glass statussignal / tool(parameter)Glass sta ...

    Head Lamps. Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper. (Refer to the BD group - "Front bumper") ...