Hyundai Sonata: Oil Cooler Repair procedures - Lubrication System - Engine Mechanical SystemHyundai Sonata: Oil Cooler Repair procedures

Removal
1.
Loosen the drain plug and drain the coolant. Open the radiator cap to make rapid draining.
(Refer to Cooling System - "Coolant")
2.
Disconnect the oil cooler hose (A).

3.
Remove the oil filter (A) with the SST (09263-2E000, the oil filter wrench).

4.
Loosen the mounting bolt (A), and then remove the oil cooler (B).

Installation
1.
Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler (C) with fix bolt (B).

Tightening torque :
50.0 ~ 55.8 N.m (5.1 ~ 5.7kgf.m, 36.8 ~ 41.2 lb-ft)

2.
Install the oil filter (A) with the SST (09263-2E000, the oil filter wrench).

Tightening torque :
11.7 ~ 15.6 N.m (1.2 ~ 1.6kgf.m, 8.6 ~ 11.5 lb-ft)

3.
Install the oil cooler (A).

4.
Fill the radiator with coolant and check for leaks.
    Oil Level Gauge & Pipe Repair procedures
    Removal and Installation 1. Remove the oil lever gauge (A). Tightening torque: 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft) 2. Install in the reverse order of removal. ...

    See also:

    SRS Control Module (SRSCM) Repair procedures
    Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. (Refe ...

    Components and Components Location
    Components Location 1. Engine Control Module (ECM) 2. Manifold Absolute Pressure Sensor (MAPS) 3. Intake Air Temperature Sensor (IATS) 4. Engine Coolant Temperature Sensor ...

    Repair procedures
    Removal Back View Camera 1. Remove the screws, clip and trunk lid trim in the trunk. (Refer to the BD group - "Trunk Lid") 2. ...