Hyundai Sonata: Oil Pressure Switch Repair procedures - Lubrication System - Engine Mechanical SystemHyundai Sonata: Oil Pressure Switch Repair procedures

Removal and Installation
1.
Remove the under cover.
2.
Remove the oil drain plug, and drain the oil into a container.
3.
Remove the oil pressure switch (A).

Tightening torque :
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

4.
Install in the reverse order of removal.
Inspection
1.
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.

2.
Check the continuity between the terminal and the body when the fine wire is pushed.
If there is continuity even when the fine wire is pushed, replace the switch.

3.
If there is no continuity when a 49.0kpa (0.5kg/cm?, 7.1psi) is applied through the oil hole, the switch is operating properly.
Check for air leakage. If air leaks, the diaphragm is broken.
Replace it.
    Oil Pump Repair procedures
    Removal and Installation 1. Remove the timing chain cover. (Refer to Timing System - "Timing Chain Cover") 2. Remove the pump cover (A). Tightening torque : 8.8 ~ 13.7N.m (0.9 ~ 1.4kgf.m, ...

    Oil Pan Components and Components Location
    Components 1. Gasket2. Oil screen3. Oil pan4. Drain plug gasket5. Drain plug ...

    See also:

    Driver Airbag (DAB) Module and Clock Spring Description and Operation
    Description Driver Airbag (DAB) is installed in the steering wheel and electrically connected to SRSCM via the clock spring. It protects the driver by deploying the airbag when frontal crash oc ...

    Emergency Fastening Device (EFD) Components and Components Location
    Components ...

    Wipers and washers
    A : Wiper speed control · MIST – Single wipe · OFF – Off · INT – Intermittent wipe · LO – Low wiper speed · HI – High wiper speed B : Intermittent or Auto control wipe time ad ...