Hyundai Sonata: Passenger Airbag (PAB) Module Repair procedures - Airbag Module - RestraintHyundai Sonata: Passenger Airbag (PAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Upper Cover Assembly")
3.
Disconnect the passenger airbag connector (A) and remove the PAB mounting bolts (B).

4.
Remove the crash pad.
(Refer to Body - "Main Crash Pad Assembly")
   
Replace the crash pad which that has been damaged after the PAB has been deployed.
5.
Remove the heater duct from the crash pad.
6.
Remove the mounting bolts from the crash pad. And then remove the passenger airbag.
   
The removed airbag module should be stored in a clean, dry place with the airbag cushion up.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
3.
Place the passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.

Tightening torque:
4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.4 lb-ft)

4.
Install the heater duct to the crash pad.
5.
Install the crash pad.
(Refer to Body - "Main Crash Pad Assembly")
6.
Tighten the passenger airbag crash pad mounting bolts.

Tightening torque:
9.0 ~ 11.0 N.m (0.9 ~ 1.2 kgf.m, 4.28 ~ 8.1 lb-ft)

7.
Connect the passenger airbag harness connector to the SRS main harness connector.
8.
Reinstall the glove box.
(Refer to Body - "Glove Box Upper Cover Assembly")
9.
Reconnect the battery negative cable.
10.
After installing the passenger airbag (PAB), confirm proper system operation :
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
    Side Airbag (SAB) Module Description and Operation
    Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag b ...

    See also:

    Fan speed control
    The ignition switch must be in the ON position for fan operation. The fan speed control knob allows you to control the fan speed of the air flowing from the ventilation system. To change the fa ...

    Mode selection
    Type A The mode selection button controls the direction of the air flow through the ventilation system. The air flow outlet port is converted as follows: Refer to the illustration in the “M ...

    Indicator symbols on the instrument cluster
    Seat belt warning light High beam indicator Turn signal indicator ESC indicator (ESC malfunction indicator) ESC OFF indicator ABS warning light Parking brake & Brake fluid warning ...