Hyundai Sonata: Power Door Lock Switch Repair procedures - Power Door Locks - Body Electrical SystemHyundai Sonata: Power Door Lock Switch Repair procedures

Inspection
Diagnosis with GDS
1.
The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information.
(1)
Self diagnosis : Checking the failure code (DTC) and display
(2)
Current data : Checking the system input/output data state
(3)
Actuation test : Checking the system operation condition
(4)
Additional function : Other controlling such as he system option and zero point
2.
Select the "Car Model" and the system to be checked in order to check the vehicle with the tester.
3.
Select the "Body Control Module (BCM)" to check the driver seat or assistant door module (DDM/ADM).
4.
Select the "Current Data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the driver seat or assistant door module(DDM/ADM) can be checked.

5.
If you will check the power door lock operation forcefully, select "Actuation test".
Removal
   
Be careful not to scratch the door trim and other parts.
Use caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil.
Driver Power Window Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
3.
Remove the power window switch assembly after disengaging the mounting clips.

   
-
Replace any damaged clips.

Installation
1.
Install the power window switch assembly.
2.
Install the front door trim after connect the connector.
3.
Connect the negative (-) battery terminal.
    Power Door Lock Module Repair procedures
    Inspection     • Wrap the protective tape on the tool to disassemble with the screwdriver or remover. • Use caution in keeping and handling during disassembling/asse ...

    See also:

    Oil Level Gauge & Pipe Repair procedures
    Removal and Installation 1. Remove the oil lever gauge (A). Tightening torque: 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft) 2. Install in the reverse order of removal. ...

    Components and Components Location
    Components 1. Steering wheel 2. Steering column 3. ECU 4. Motor 5. Steering gear box ...

    Front Impact Sensor (FIS). Components and Components Location
    Components ...