Hyundai Sonata: Power Seat Control Switch Repair procedures - Seat Electrical - Body Electrical SystemHyundai Sonata: Power Seat Control Switch Repair procedures

Inspection
Diagnosis with GDS
1.
The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information.
(1)
Self diagnosis : Checking the failure code (DTC) and display
(2)
Current data : Checking the system input/output data state
(3)
Actuator test : Checking the system operation condition
(4)
Additional function : Other controlling such as he system option and zero point adjustment
2.
Select the "Car Model" and the system to be checked in order to check the vehicle with the tester.
3.
Select the "Power Seat Module (PSM)" to check the power seat module (PSM).
4.
Select the "Current Data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the power seat module (PSM) can be checked.
Seat Control Switch
1.
With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch.

[Manual Seat Control Switch]

[Power Seat Control Switch]

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front seat outer shield cover.
(Refer to Body - "Front Seat Outer Shield Cover")
3.
Remove the power seat control switch (A) after loosening the screws.

Installation
1.
Install the power seat control switch after connecting the connector.
2.
Install the front seat outer shield cover.
3.
Connect the negative (-) battery terminal.
    See also:

    Smart key
    With a smart key, you can lock or unlock a door (and trunk) and even start the engine without inserting the key. The functions of buttons on a smart key are similar to the remote keyless entry. ...

    Front Hub / Knuckle. Repair procedures - Revised
    Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel an ...

    Seat Belt Buckle Switch (BS). Repair procedures
    Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat asse ...