Hyundai Sonata: Purge Control Solenoid Valve (PCSV) Repair procedures - Engine Control System - Engine Control / Fuel SystemHyundai Sonata: Purge Control Solenoid Valve (PCSV) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the purge control solenoid valve connector (A).
3.
Disconnect the vapor hoses (B) from the purge control solenoid valve.
4.
Remove the installation bolt (C), and then remove the PCSV (D) from the engine.

Installation
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
Use care to keep foreign material out of the valve.
1.
Install in the reverse order of removal.

Purge control solenoid valve bracket installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    CVVT Oil Control Valve (OCV) Description and Operation
    Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by ...

    See also:

    Power Door Lock Switch Repair procedures
    Inspection Diagnosis with GDS 1. The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS). The diagnostic system (GDS) provides the following informa ...

    Opening the hood
    WARNING Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P(Park) position for automatic transaxle and to the 1st(First) gear or R(Reverse) for man ...

    Rear Parking Assist System Switch Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the console upper cover. (Refer to Body - "Floor Console Assembly") 3. Remove the rear curtain switch (A) after loosenin ...