Hyundai Sonata: RCV Control Solenoid Valve Repair procedures - Engine Control System - Engine Control / Fuel SystemHyundai Sonata: RCV Control Solenoid Valve Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the RCV connector.
3.
Measure resistance between the RCV terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to "Specification"

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Remove the air duck (A).
(Refer to Engine Mechanical System - "Air Cleaner")
3.
Disconnect the RCV control solenoid valve connector (A) and vapor hoses (B).
4.
Remove the RCV control solenoid valve (D) by loosening the mounting bolts (C).

Installation
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.

RCV control solenoid valve bracket installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Fuel Pressure Control Valve Description and Operation
    Description Fuel Pressure Control Valve (FPCV) is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based o ...

    See also:

    Roller Blind Repair procedures
    Removal 1. Open the roller blind using the panorama sunroof switch.     • Leave 10 ~ 20cm (0.3937 ~ 0.7874 in) of the roller blind unopened. 2. Remove the roof trim ...

    Specifications
    Specifications Purge Control Solenoid Valve (PCSV) ? Specification ItemSpecificationCoil Resistance (?)22.0 ~ 26.0 [20°C(68°F)] Fuel Tank Pressure Sensor (FTPS) ? Type: Piezo-Resistive ...

    Trunk Lid Weatherstrip Repair procedures
    Replacement 1. Remove the trunk lid weatherstrip (A).     • Do not apply sealant to the body. 2. Install in the reverse order of removal.     ...