Hyundai Sonata: Rear Bumper Beam Assembly Repair procedures - Rear Bumper - Body (Interior and Exterior)Hyundai Sonata: Rear Bumper Beam Assembly Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the rear bumper cover.
(Refer to Rear Bumper - "Rear Bumper Cover")
2.
After loosening the mounting clips, then remove the rear bumper center under cover (A).

3.
Disconnect the rear bumper beam mounting wiring harness.
4.
Remove the mounting clips (A), then remove the rear bumper beam assembly (B).

5.
Install in the reverse order of removal.
   
Make sure the connector is connected properly.
Replace any damage clips.
    Rear Bumper Beam Assembly Components and Components Location
    Component Location 1. Rear bumper beam assembly ...

    See also:

    Condenser Repair procedures
    Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. ...

    Heater Core Repair procedures
    Replacement 1. Disconnect the negative (-) battery terminal. 2. After loosening the bolts remove the main crash pad and cowl cross bar assembly together. (Refer to Heater -"Heater Unit") ...

    AVN Antenna Components and Components Location
    Components ...