Hyundai Sonata: Rear Door Latch Repair procedures - Rear Door - Body (Interior and Exterior)Hyundai Sonata: Rear Door Latch Repair procedures

Replacement
1.
Remove the rear door module.
(Refer to Rear Door - "Rear Door Module")
2.
Disconnect the rear door latch connector (A).

3.
Remove the rear door inside handle cage (A).

4.
Remove the rear door inside handle cable (A) by pushing it rearward.

5.
Remove the rear door outside handle base (A) by pushing in the lock pins located in the back.

6.
Remove the rear door outside handle cable (A).

7.
Install in the reverse order of removal.
   
Make sure the connector is connected properly.
Make sure the door locks / unlocks and opens / closes properly.
Replace any damaged clips.
    Rear Door Latch Components and Components Location
    Component Location 1. Rear door latch ...

    Rear Door Curtain Assembly Repair procedures
    Replacement     Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective ...

    See also:

    Opening the hood
    WARNING Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P(Park) position for automatic transaxle and to the 1st(First) gear or R(Reverse) for man ...

    Fuel Pump Control Module (FPCM) Schematic Diagrams
    Circuit Diagram Fuel Pressure Control Module (FPCM) Terminal And Input/Output signal FPCM Terminal Function Pin No.DescriptionConnected to1Fuel sender ground Fuel Pump 2Fuel pressure sensor (FPS) ...

    Heated Steering wheel Schematic Diagrams
    Schematic diagram Terminal function Pin NoFunctionA2Heated steering powerA3Swtich signalA13NTC (-)C9NTC (+) ...