Hyundai Sonata: Rear Door Trim Repair procedures - Rear Door - Body (Interior and Exterior)Hyundai Sonata: Rear Door Trim Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Be careful not to scratch the door trim and other parts.
1.
Using a screwdriver or remover, remove the rear door derta inner cover (A).

2.
Using a flat-tip or remover, remove the rear door pull cap (A).

3.
Pull the front door inside handle using a flat head screwdriver and remove the cap (A) using the hole located inside of the handle.

4.
After loosening the mounting screws, then remove the rear door trim (A) by using a flat-tip screwdriver.

5.
Remove the rear door inside handle cage (A).
6.
Disconnect the power window switch connector (B).

7.
Remove the rear door side curtain assembly.
(Refer to Rear Door - "Rear Door Side Curtain Assembly")
8.
Install in the reverse order of removal.
   
Make sure the connector is connected properly.
Make sure the door locks / unlocks and opens / closes properly.
Replace any damaged clips.
    Rear Door Trim Components and Components Location
    Component Location 1. Rear door trim ...

    Rear Door Inside Handle Repair procedures
    Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the rear door side curtain assembly. (Refer to Rear Door - "Rear door side curtain assembly") ...

    See also:

    Steering Column and Shaft. Repair procedures
    Replacement 1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so ...

    Repair procedures
    Inspection Front Door Lock Actuator Inspection 1. Remove the front door trim. (Refer to the BD group - "Front door") 2. R ...

    Schematic Diagrams
    Circuit Diagram ...