Hyundai Sonata: Rear Hub Assembly Repair procedures - Rear Axle Assembly - Driveshaft and axleHyundai Sonata: Rear Hub Assembly Repair procedures

Replacement
1.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the wheel cap (A).

   
Be careful not to damage to the wheel cap (A) when removing the it.
3.
Remove the front wheel and tire (A) from front hub.

Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

   
Be careful not to damage to the hub bolts when removing the front wheel and tire (A).
4.
Remove the brake caliper mounting bolts and then place the brake caliper assembly (A) with wire.

Tightening torque :
78.4 ~ 98.0 N.m (8.0 ~ 10.0 kgf.m, 57.8 ~ 72.3 lb-ft)

[General]

[EPB]

5.
Loosen the mount screw and then brake disc (A).

Tightening torque :
4.9 ~ 5.8 N.m (0.5 ~ 0.6 kgf.m, 3.6 ~ 5.3 lb-ft)

6.
Disconnect the wheel speed sensor connector (A).

7.
Loosen the mounting bolts and remov it.

Tightening torque :
58.3 ~ 68.6 N.m (6.0 ~ 7.0 kgf.m, 43.4 ~ 50.6 lb-ft)

8.
Install in the reverse order of removal.
    Rear Hub - Carrier Repair procedures
    Removal 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A).     Be careful not to damage to the wheel cap (A) when removing the it. ...

    See also:

    Power Door Lock Actuators. Repair procedures
    Inspection Front Door Lock Actuator Inspection 1. Remove the front door trim. (Refer to the BD group - "Front door") 2. R ...

    Crankshaft Position Sensor (CKPS) Repair procedures
    Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) ...

    Alternator. Repair procedures
    Removal and Installation 1. Disconnect the battery negative terminal first, then the positive terminal. Tightening torque : (+) term ...