Hyundai Sonata: Rear Package Tray Trim Repair procedures - Interior Trim - Body (Interior and Exterior)Hyundai Sonata: Rear Package Tray Trim Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Slighty remove the rear door weatherstrip.
4.
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
5.
Remove the rear pillar trim.
(Refer to Interior Trim - "Rear Wheel House Trim")
6.
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

[LH]

[RH]

7.
After loosening the mounting screws, then remove the rear package tray trim (A).

8.
Install in the reverse order of removal.
   
Make sure the connector is connected properly.
Replace any damage clips.
    Rear Package Tray Trim Components and Components Location
    Component Location 1. Rear package tray trim ...

    See also:

    Power Seat Motor. Repair procedures
    Inspection Power Seat Motor 1. Disconnect the connectors for each motor. A : Front height motor B : Slide motor C : Rear height motor D : Re ...

    Trunk lamp
    The trunk room lamp comes on when the trunk is opened. CAUTION The trunk lamp comes on as long as the trunk lid is open. To prevent unnecessary charging system drain, close the trunk lid secur ...

    Repair procedures
    On-vehicle Inpection     • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide) ...