Hyundai Sonata: Rear Wheel Guard Repair procedures - Body Side Molding - Body (Interior and Exterior)Hyundai Sonata: Rear Wheel Guard Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the rear tire.
2.
After loosening the mounting clips and screws, then remove the rear wheel guard (A).

3.
Install in the reverse order of removal.
   
Replace any damaged clips.
    Front Wheel Guard Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with pr ...

    Fender Garnish Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with pro ...

    See also:

    Ambient Temperature Sensor (ATS) Schematic Diagrams
    Circuit Diagram ...

    Components and Components Location
    Components Location 1. PCV Valve 2. Canister 3. Purge Control Solenoid Valve (PCSV) 4. Fuel Tank Pressure Sensor (FTPS) 5. Canister Close Valve (CCV) 6. Fuel ...

    Assist Handle Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...