Hyundai Sonata: Repair procedures - Panorama Sunroof - Body (Interior and Exterior)Hyundai Sonata: Repair procedures

Adjustment
Inspect Glass Alignment
1.
Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it.

Alignment adjustment
Standard value [mm(in.)]
(1) Front edge : 0 mm (0 in.)
(2) Rear edge : 0 mm (0 in.)

2.
Completely open the movable glass using the panorama sunroof switch.
3.
Remove both sides of the decoration cover (A).

4.
Completely close the movable glass using the panorama sunroof switch.
5.
Adjust the height of the glass by slighty loosening the screws (A).
   
•
Be careful not to damage the screw.

Emergency operation
1.
Use the panorama sunroof emergency operation only when you have to open or close the sunroof when there is a problem with the engine.
2.
Use a hexagon wrench to open or close the panorama sunroof after removing the roof trim. Do not apply too much force when opening or closing the panorama sunroof.
[Movable Glass Motor "A"]

[Roller Blind Motor "B"]

3.
If needed reset the panorama sunroof according to the reset method.
    Components and Components Location
    Components 1. Glass motor2. Roller blind motor3. Mechanism assembly4. Front decoration cover 5. Wind deflector6. Center cover assembly7. Roof side moulding8. Inner decoration cover 9. Rear glass1 ...

    Movable Glass Repair procedures
    Replacement 1. Completely open the movable glass using the panorama sunroof switch. 2. Remove both sides of the decoration cover (A). 3. Completely close the movable glass using the panora ...

    See also:

    ETC (Electronic Throttle Control) System. Schematic Diagrams
    Circuit Diagram ...

    Starting the engine
    WARNING Always wear appropriate shoes when operating your vehicle. Unsuitable shoes (high heels, ski boots, etc.) may interfere with your ability to use the brake and accelerator pedal. 1. Carry ...

    Curtain Airbag (CAB) Module Repair procedures
    Removal 1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the roof trim. (Refer to Body - "Roof Trim Assembly") 3. Disconnect the c ...