Hyundai Sonata: Roof Side Molding Repair procedures - Body Side Molding - Body (Interior and Exterior)Hyundai Sonata: Roof Side Molding Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the roof side molding (A).
   
Always replace the roof side molding to a new one.

2.
Install in the reverse order of removal.
   
Replace any damaged clips.
    Delta Garnish Repair procedures
    Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

    See also:

    Cylinder Block Components and Components Location
    Components 1.  Cylinder block2.  Ladder frame3.  Crank shaft4.  Crank shaft upper bearing5.  Crank shaft lower bearing6.  Thrust bearing7.  Main bearing cap8.&n ...

    Emergency Fastening Device (EFD) Repair procedures
    Removal 1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the front seat. (Refer to Body - "Front Seat Assembly") 3. Remove the rea ...

    Rear Seat Folding Lever Components and Components Location
    Components 1. Rear seat folding lever ...