Hyundai Sonata: Seat Belt Buckle Switch (BS) Repair procedures - SRSCM - RestraintHyundai Sonata: Seat Belt Buckle Switch (BS) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
3.
Loosen the seat belt buckle mounting bolt and remove the seat belt buckle switch (A).

Installation
   
Be sure to install the harness wires so they will not pinch or interfere with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the seat belt buckle switch.

Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)

4.
Install the front seat assembly.
(Refer to Body - "Front Seat Assembly")
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle switch, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.
    Schematic Diagrams
    Circuit Diagram (1) Circuit Diagram (2) Circuit Diagram (3) SRSCM Connector Terminal PinFunction (Connector A)PinFunction (Connector B)A1IGN-1B1Side impact sensor front, Passenger-High (+)A2Fr ...

    See also:

    Components and Components Location
    Component Location (1) 1. Smart key unit (SMK)2. Interior antenna 23. Door outside handle4. Interior antenna 15. Buzzer Component Location (2) 1. Trunk open switch2. Bumper antenna3. Trunk ...

    Instrument Cluster Repair procedures
    Removal     • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the re ...

    Power Seat Motor Components and Components Location
    Component Location 1. Slide motor2. Front height motor3. Air ventilation seat blower4. Reclining motor5. Lumbar support motor (Vertical)6. Lumbar support motor (Horizontal)7. Rear height motor8. ...