Hyundai Sonata: Seat Belt Pretensioner (BPT) Repair procedures - Seat Belt Pretensioner - RestraintHyundai Sonata: Seat Belt Pretensioner (BPT) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the door scuff trim.
(Refer to Body - "Interior Trim")
3.
Remove the center pillar trim.
(Refer to Body - "Interior Trim")
4.
Loosen the seat belt pretensioner mounting bolts (A) and remove the seat belt pretensioner.
5.
Disconnect the seat belt pretensioner connector (B).

Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the seat belt pretensioner with bolts (A).
4.
Connect the seat belt pretensioner connector (B).

Tightening torque:
Bolt B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)

5.
Install the center pillar trim.
(Refer to Body - "Interior Trim")
6.
Install the door scuff trim.
(Refer to Body - "Interior Trim")
7.
Insert the seat belt to the anchor pretensioner.
   
Make sure the lock pin is connected in properly.
8.
Reconnect the battery negative cable.
9.
After installing the seat belt pretensioner, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
    Emergency Fastening Device (EFD) Description and Operation
    Description The Emergency Fastening Device (EFD) operates at the same time with the Seat Belt Pretensioner when it satisifies the deployment condition after a collision. It is an auxiliary equi ...

    See also:

    AVN Antenna Repair procedures
    Inspection Glass Antenna Test 1. Wrap aluminum foil (A) around the tip of the tester probe (B) as shown. 2. Touch one tester probe to the glass antenna terminal (A) and move the other teste ...

    Air intake control
    Type A Type B This is used to select the outside (fresh) air position or recirculated air position. To change the air intake control position, push the control button. Recirculated air po ...

    Antenna Coil Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Disconnect the 6P connector (B) of the coil ante ...