Hyundai Sonata: Shift Lever Repair procedures - Dual Clutch Transmission Control System - DCT (Dual Clutch Transmission) SystemHyundai Sonata: Shift Lever Repair procedures

Removal
1.
Disconnect a boots from the console upper cover.
2.
Pull the knob (A) in the direction of "F" and remove the knob.

3.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
4.
Disconnect the connector (A) from the shift lever.

5.
Disconnect the control cable (A).
(1)
Disconnect the cable holer (A) from the shift lever.
(2)
Disconnect the cable bracket from the shift lever after pushing the lock.

6.
Remove the bolts and then shift lever assembly (A).

Tightening torque :
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

7.
Remove the P position switch mounting bracket (A).

8.
Disconnect the P position switch (A) and shift lock solenoid (B).

9.
Disconnect the main connector (A) from the shift lever.

10.
Remove the mounting bracket (A) of terminals from the main connector.

11.
Remove each terminals of the P position switch (A), shift lock solenoid (B) from the main connector (C).
   
Record the location of the wiring colors before disconnecting the terminals.

   
? Connector information

3. Shift lock solenoid (-)
4. Shift lock solenoid (+)
5. DCT sensor_IG1
6. CAN (High)
7. CAN (Low)
8. DCT sensor_ground
9. P(Parking) Position switch (-)
10. P(Parking) Position switch (+)
Installation
1.
Install in the reverse order of removal.
   
Install the cable after placing the shift lever and the manual control lever in the N position.
    Shift Lever Schematic Diagrams
    Circuit Diagram ...

    Shift Cable Components and Components Location
    Components 1. Shift lever knob2. Shift lever assembly3. Shift cable4. Shift cable retainer ...

    See also:

    Balance Shaft & Oil Pump. Components and Components Location
    Components 1. Balance shaft & oil pump assembly 2. Balance shaft chain tensioner 3. Balance shaft chain 4. Balance shaft chain sprocket 5. Balance shaft cha ...

    Specifications
    Specifications Item Specification Master cylinder Type Tandem Cylinder I.D. 22.22mm Pisto ...

    Master Cylinder. Repair procedures
    Removal 1. Turm ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly (A). ...