Hyundai Sonata: Trunk Lid Back Panel Repair procedures - Trunk Lid - Body (Interior and Exterior)Hyundai Sonata: Trunk Lid Back Panel Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Remove the inside rear combination lamp.
(Refer to Body Electrical System - "Rear combination lamp")
3.
Loosen the mounting nut, remove the trunk lid panel (A).

4.
Install in the reverse order of removal.
   
Make sure the connector are connected in properly.
Replace any damaged clips.
    Trunk Lid Back Panel Components and Components Location
    Component Location 1. Trunk lid back panel ...

    Trunk Lid Weatherstrip Repair procedures
    Replacement 1. Remove the trunk lid weatherstrip (A).     • Do not apply sealant to the body. 2. Install in the reverse order of removal.     ...

    See also:

    Radiator. Repair procedures
    Removal and Installation 1. Disconnect the battery terminals. (Refer to Engine and transaxle assembly in this group) 2. Remove the air ...

    Schematic Diagrams
    Schematic [EPB Type] [General Type] Terminal Funtion [EPB Type] PIN NODesciptionCurrentmaxmin1Voltage supply for pump motor39A 10A 2RR EPB motor power30A - 3RR EPB m ...

    Front Seat Assembly Components and Components Location
    Component Location 1. Front seat assembly ...