Hyundai Sonata: Trunk Lid Key Holder Repair procedures - Trunk Lid - Body (Interior and Exterior)Hyundai Sonata: Trunk Lid Key Holder Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Loosen the trunk lid key holder mounting nuts.
3.
Remove the trunk lid key holder (B) and disconnect the trunk lid key holder cable (A).

Tightening torque :
6.9 ~ 8.8 N.m (0.7 ~ 0.9 kgf.m, 5.1 ~ 6.5 lb-ft)

4.
Install in the reverse order of removal.
   
Make sure the trunk lid locks / unlocks and opens / closes properly.
Replace any damaged clips.
    Trunk Lid Trim Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with pr ...

    Trunk Lid Back Panel Components and Components Location
    Component Location 1. Trunk lid back panel ...

    See also:

    Heater & A/C Control Unit (Manual) Components and Components Location
    Components Connector [A] Pin NOFunctionPin NOFunction1ILL+ (TAIL)21Detent OUT (+)2Sensor REF (+5V)22HTD3Mode control actuator (Vent)23Rear defog switch4Mode control actuator (Defrost)24C_CAN High5 ...

    Ambient Temperature Sensor (ATS) Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ATS connector. 3. Measure resistance between the ATS terminals 1 and 2 [B1/S1]. 4. Check that the resistance is within the ...

    Heated Oxygen Sensor (HO2S) Specifications
    Specification HO2S [Bank 1/Sensor 1] (Linear type) ItemSpecificationHeater Resistance (?)2.4 ~ 4.0 [20°C(68°F)] ItemSpecificationHeater Resistance (?)Approx. 9.0 [20°C(68°F)] HO2S [Ba ...