Hyundai Sonata: Water Temperature Control Assembly Repair procedures - Cooling System - Engine Mechanical SystemHyundai Sonata: Water Temperature Control Assembly Repair procedures

Removal and Installation
1.
Loosen the drain plug, and drain the engine coolant. Remove the radiator cap to drain with speed.
2.
Disconnect the battery negative terminal.
3.
Remove the air cleaner assembly.
(Refer to Intake and exhaust system - "Air Cleaner")
4.
Disconnect the water temperature sensor connector (A).
5.
Disconnect the radiator upper hose (B).
6.
Remove the heater hose (C).
7.
Disconnect the water hose (D).

8.
Remove the water temperature control assembly (B).

Tightening torque :
9.8 ~ 11.7N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

9.
Install in the reverse order of removal.
   
Clean the surface of the water temperature control assembly before installing.
    Water Temperature Control Assembly Components and Components Location
    Components 1. Water temperature control assembly2. Water temperature sensor3. Gasket ...

    Water Pipe Components and Components Location
    Components 1. Water pipe ...

    See also:

    Limitation of Active ECO operation
    If the following conditions occur while Active ECO is operating, the system operation is limited even though there is no change in the ECO indicator. When the coolant temperature is low: The sys ...

    CVVT Oil Control Valve (OCV). Description and Operation
    Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated ...

    Door Mood Lamp Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front Door Trim") 3. Disconnect the door mood lamp connector. 4. Remove the ...