Hyundai Sonata: Wheel Repair procedures - Tires/Wheels - Suspension SystemHyundai Sonata: Wheel Repair procedures

Hub nut tightening sequence
Tighten the hub nuts as follows.

Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

   
When using an impact gun, final tightening torque should be checked using a torque wrench.
Run out inspection
1.
Jack up the vehicle.
2.
Measure the wheel Run-out by using a dial indicator as illustration below.
Run-out
Aluminum
Radial mm(in.)
Below 0.3(0.012)
Lateral mm(in.)
Below 0.3(0.012)

3.
If measured value exceeds the standard value, replace the wheel.

    Tire Repair procedures
        • Using tires and wheel other than the recommended sizes could cause unusual handling characteristics and poor vehicle control, resulting in a serious accident. Tir ...

    Alignment Repair procedures
    Front Wheel Alignment     When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a lev ...

    See also:

    PDM(Power Distribution Module). Components and Components Location
    Component ...

    Electric WGT Control Actuator Specifications
    Specification [EWGA Position Sensor] Position Output Voltage[V] Operating Angle[°] Range of Rod [mm], reference Mechanical Close end stop Position (MCP) 4.8 0 0 Electrical Close end ...

    Smooth cornering
    Avoid braking or gear changing in corners, especially when roads are wet. Ideally, corners should always be taken under gentle acceleration. If you follow these suggestions, tire wear will be ...